Stamping press 100 t
Speeds
| Operation | Value | Unit | Note | Open |
|---|---|---|---|---|
Stamping cycle with progressive die (blank, pierce, form up to 2 bends) | 6 | s per part | After setup; sheet parts up to 150x100 mm, up to 3 mm |
Rules
| ID | Type | Rule | Value | Unit | Open |
|---|---|---|---|---|---|
R4 | Routing | If the annual volume of a sheet part is ABOVE the Value, recommend the stamping route (M3 with a progressive die, see sheet Tooling) instead of laser plus press brake. Use the annual volume stated on the drawing, not the order quantity. | 5000 | pcs per year | |
R11 | Routing | When R4 applies: quote the stamping route as the recommended option AND show the laser plus press brake route as an alternative for comparison, with the break-even volume. | |||
R12 | Commercial | Die (tooling) cost is a one-off charge, shown on a separate quote line, and gets the same margin as R8. | |||
R13 | Lead time | Lead time when a die is needed: die lead time (table Tooling, in weeks; the Value is working days per week) PLUS the standard lead time of R5. Express (R14) is not available for the first batch. | 5 | working days per week |
Tooling
| Die ID | Applies to | Die cost EUR | Lead time (weeks) | Note | Open |
|---|---|---|---|---|---|
DIE-S1 | Progressive die for sheet part up to 150x100 mm, up to 3 mm thick, up to 2 bends of 90 deg | 5000 | 8 | One-off cost; die stays property of the customer |
